The Digital Texas Instruments Interview Questions are completely memory-based. Refer to these given questions and prepare accordingly. Please keep in mind that these are not the exact question that may come in the Interview test and the values given in the questions may also differ. 1. Ripple counter shown below works as (assume the preset is the asynchronous and initial state is 0 for all three flip-flops). Options 1. Mod 5 Down counter2. Mod 3 Up counter3. Mod 3 Down counter4. Mod 5 Up counter 2. An AND gate drives a load whose capacitance is much higher than the parasitic capacitance of the transistor inside the AND gate. Signal A is a 200 MHz clock. Signal B is a 400 MHz clock whose edges

# Tag: TI Interview

# Texas Instruments Analog Interview Questions 2021

Memory-based analog-based questions that appeared in Texas Instruments Interview. Try to solve similar kinds of questions in order to excel in your preparation level. The parameter values given in the questions to design may be different. 1. What should be the value of Zs that will transfer maximum power to the ZL? R=50 Ohms and L=5H. Options 1. 50-jw5 Ohms 2. 50 Ohms 3. 60+jw5 Ohms 4. 0 Ohms 2. The Op-amp in the circuit shown below is an ideal op-amp. What is the output impedance Zout? if Rs=100 Ohms. Options 1. 0 Ohms 2. 0.010 Ohms 3. 100 Ohms 4. Infinity 3. Op-amp in the below circuit is ideal. A sine wave of frequency 1mrad/s and amplitude of 1V is applied at Vin. What is the amplitude at node Vout? If R